Nissan Juke Service and Repair Manual : Wiring diagram

BRAKE CONTROL SYSTEM

Wiring Diagram

For connector terminal arrangements, harness layout, and alphabets in a described in wiring diagram), refer to GI-12, "Connector Information/Explanation (option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation".

Basic inspection


    ECU diagnosis information
    ABS actuator and electric unit (control unit) Reference Value CONSULT-III DATA MONITOR STANDARD VALUE *1: Confirm tire pressure is standard value. *2: Refer to “valve operation” in BRC-13, &qu ...

    Basic inspection
    Diagnosis and repair work flow Work Flow DETAILED FLOW 1.INTERVIEW FROM THE CUSTOMER Clarify customer complaints before inspection. First of all, perform an interview utilizing BRC-34, "Dia ...

    Other materials:

    P1650 starter motor relay 2
    Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. Models with no Intelligent Key System transmit a control signal directly to IPDM E/R. On the other hand, models with the Intelligent Key System transmit a control signal to IPDM E/R by w ...

    P1553 battery current sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. ...

    Idle air volume learning
    Description Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps each engine idle speed within the specific range. It must be performed under any of the following conditions: • Each time electric throttle control actuator or ECM is replaced. • Idle speed or i ...