Nissan Juke Service and Repair Manual : System description

Precaution for Brake Control system
• Always perform a pre-driving check to drive the vehicle.• Always perform a pre-driving check to drive the vehicle. • Always check speed and safety while driving the vehicle. • Always c ...

Component parts
Component Parts Location LHD 1. ABS actuator and electric unit (control unit) 2. Front wheel sensor 3. Stop lamp switch 4. Rear wheel sensor A. Inside engine room B. Steering knuckle C. ...

Other materials:

Warning/Indicator lights (yellow)
or Anti-lock Braking System (ABS) warning light When you place the power switch in the ON or "READY to drive" position, the Anti-lock Braking System (ABS) warning light will illuminate briefly and then extinguish. This serves as a standard system self-check to confirm ...

P0500 VSS
Description The vehicle speed signal is sent to the combination meter from the “ABS actuator and electric unit (control unit)” by CAN communication line. The combination meter then sends a signal to the ECM by CAN communication line. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P050 ...

Cylinder head
Exploded View REMOVAL 1. Cylinder head assembly 2. Cylinder head bolt 3. Cylinder head gasket A. Tightening must be done following the installation procedure. Refer to EM-91 : N·m (kg-m, ft-lb) : Always replace after every disassembly. : Should be lubricated with oil. DISASSEMBLY ...