Nissan Juke Service and Repair Manual : Push-button ignition switch does not operate

Description

Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom.

NOTE

:
The engine start function, door lock function, power distribution system, and NATS-IVIS/NVIS in the Intelligent Key system are closely related to each other regarding control. The vehicle security function can operate only when the door lock and power distribution system are operating normally.

Conditions of Vehicle (Operating Conditions) • “ENGINE START BY I-KEY” in “WORK SUPPORT” is ON when setting on CONSULT-III.

• One or more of Intelligent Keys with registered Intelligent Key ID is in the vehicle.

Diagnosis Procedure

1.PERFORM WORK SUPPORT

Perform “INSIDE ANT DIAGNOSIS” on Work Support of “INTELLIGENT KEY”.

Refer to DLK-41, "DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK) (With Super Lock)", DLK-217, "DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK) (Without Super Lock)".

>> GO TO 2.

2.PERFORM SELF-DIAGNOSIS RESULT

Perform Self-Diagnosis Result of “BCM”.

Is DTC detected? YES >> Refer to BCS-67, "DTC Index".

NO >> GO TO 3.

3.CHECK PUSH-BUTTON IGNITION SWITCH

Check push-button ignition switch.

Refer to PCS-108, "Component Function Check".

Is the operation normal? YES >> GO TO 4.

NO >> Repair or replace malfunctioning parts.

4.CONFIRM THE OPERATION

Confirm the operation again.

Is the inspection normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 1.

    Push-button ignition switch position indicator does not illuminate
    Description • Before performing the diagnosis in the following table, check “Work Flow”. Refer to PCS-88, "Work Flow". • Check that vehicle is under the condition shown in “Con ...

    Other materials:

    Measurement of weights
    Secure loose items to prevent weight shifts that could affect the balance of your vehicle. When the vehicle is loaded, drive to a scale and weigh the front and the rear wheels separately to determine axle loads. Individual axle loads should not exceed either of the Gross Axle Weight Ratings ( ...

    Rear seat belt
    Exploded View 2WD models 1. Anchor bolt 2. Outer seat belt retractor RH 3. Shoulder anchor 4. Space 5. Retaining washer 6. Seat belt hook 7. Outer anchor 8. Outer seat belt retractor LH 9. Center seat belt finisher 10. Center seat belt buckle 11. RH seat belt buckle 12. Center ...

    License plate lamp circuit
    Without daytime running light system WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Component Function Check 1.CHECK TAIL LAMP (RH) OPERATION Check that the tail lamp (RH) is turned ON. Is the inspection result normal? YES >> GO TO 2. NO >> Check tail lamp circuit. Refer to EXL-61, &qu ...