Nissan Juke Service and Repair Manual : Precaution Necessary for Steering Wheel Rotation after Battery Disconnect

NOTE

:
• Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables.

• After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables.

• Always use CONSULT-III to perform self-diagnosis as a part of each function inspection after finishing work.

If a DTC is detected, perform trouble diagnosis according to self-diagnosis results.

For vehicle with steering lock unit, if the battery is disconnected or discharged, the steering wheel will lock and cannot be turned.

If turning the steering wheel is required with the battery disconnected or discharged, follow the operation procedure below before starting the repair operation.

OPERATION PROCEDURE

1. Connect both battery cables.

NOTE

:
Supply power using jumper cables if battery is discharged.

2. Turn the ignition switch to ACC position. (At this time, the steering lock will be released.)
3. Disconnect both battery cables. The steering lock will remain released with both battery cables disconnected and the steering wheel can be turned.

4. Perform the necessary repair operation.

5. When the repair work is completed, re-connect both battery cables. With the brake pedal released, turn the ignition switch from ACC position to ON position, then to LOCK position. (The steering wheel will lock when the ignition switch is turned to LOCK position.) 6. Perform self-diagnosis check of all control units using CONSULT-III.

    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
    The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and fron ...

    Precautions for Drive Shaft
    • Observe the following precautions when disassembling and assembling drive shaft. - Never disassemble joint sub-assembly because it is non-overhaul parts. - Perform work in a location which is ...

    Other materials:

    Steering switch ground circuit
    Description Transmits the steering switch signal to NAVI control unit. Diagnosis Procedure 1.CHECK STEERING SWITCH SIGNAL GROUND CIRCUIT 1. Disconnect NAVI control unit connector and spiral cable connector. 2. Check continuity between NAVI control unit harness connector and spiral cable harne ...

    Door motor
    Exploded View LEFT SIDE 1. A/C unit assembly 2. Intake door lever 3. Intake door link 4. Intake door motor 5. Air mix door motor 6. Air mix door link 7. Max. cool door 8. Upper air mix door lever 9. Air mix door rod 10. Lower air mix door lever RIGHT SIDE 1. A/C unit assembly ...

    Condenser
    Exploded View Refer toINT-34, "Exploded View" Removal and Installation REMOVAL 1. Remove the back door lower finisher. Refer to INT-35, "BACK DOOR LOWER FINISHER : Removal and Installation" 2. Remove bolt (A), and then remove condenser (1) from the vehicle body. INSTA ...