Nissan Juke Service and Repair Manual : Push-button ignition switch position indicator does not illuminate

Nissan Juke Service and Repair Manual / Power Control System Power distribution system / Symptom diagnosis / Push-button ignition switch position indicator does not illuminate

Description

• Before performing the diagnosis in the following table, check “Work Flow”. Refer to PCS-88, "Work Flow".

• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom.

Conditions of Vehicle (Operating Conditions) • “ENGINE START BY I-KEY” in “WORK SUPPORT” is ON when setting on CONSULT-III.

• One or more of Intelligent Keys with registered Intelligent Key ID is in the vehicle.

Diagnosis Procedure

1.CHECK PUSH-BUTTON IGNITION SWITCH INDICATOR

Check push-button ignition switch indicator.

Refer to PCS-111, "Component Function Check".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CONFIRM THE OPERATION

Confirm the operation again.

Is the result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 1.

    Push-button ignition switch does not operate
    Description Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom. NOTE: The engine start function, door lock functio ...

    Removal and installation
    PUSH-BUTTON IGNITION SWITCH Removal and Installation REMOVAL 1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and Installation". 2. Remove the push-button ignition switch. ...

    Other materials:

    System
    CVT control system : System Diagram CVT control system : System Description The CVT senses vehicle operating conditions through various sensors. It always controls the optimum shift position and reduces shifting and lock-up shocks. TCM FUNCTION The function of the TCM is to: • Receive ...

    P0087 fuel pump
    DTC Logic DTC DETECTION LOGIC NOTE: • Conditions for applying the diagnostic procedure to the stored DTCs: The DTC becomes present during the first 30 seconds after the engine starts. • In low ambient temperature conditions, diagnostic cannot make difference between a normal long engine ...

    TCM branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - TCM - Harness connecotor F1 - Harness ...