Push-button ignition switch position indicator

Description Push-button ignition switch changes the power supply position. BCM maintains the power supply position status. BCM changes the power supply position with the operation of the push-b ...

Push-button ignition switch does not operate

Description Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom. NOTE: The engine start function, door lock function, p ...

Other materials:

B2628 outside antenna
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Disconnect outside key antenna (rear bumper) connector. 2. Perform “INTELLIGENT KEY” Self Diagnostic Result. Is outside key antenna DTC detected? YES >> Refer to DLK-65, "Diagnosis ...

Engine overheating
Description CHART 17: ENGINE OVERHEATING Diagnosis Procedure 1.CHECK COOLING SYSTEM Check the cooling system. Refer to CO-60, "Troubleshooting Chart". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace. 2.CHECK ECM POWER SUPPLY AND GROUND CIR ...

Water hose
Exploded View 1. Hose clamp 2. Water hose A. Water outlet B. Oil warm Removal and Installation REMOVAL WARNING: Never remove the radiator cap when the engine is hot. Serious burns could occur from high pressure coolant escaping from the radiator. CAUTION: Perform these steps after t ...