Nissan Juke Service and Repair Manual : Sensor rotor

Front sensor rotor : Removal and Installatio

REMOVAL

Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled.

• MR16DDT: Refer to FAX-11, "Removal and Installation".

• HR16DE: Refer to FAX-43, "Removal and Installation".

• K9K: Refer to FAX-68, "Removal and Installation".

INSTALLATION

Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled.

• MR16DDT: Refer to FAX-11, "Removal and Installation".

• HR16DE: Refer to FAX-43, "Removal and Installation".

• K9K: Refer to FAX-68, "Removal and Installation".

Rear sensor rotor : Removal and Installation

REMOVAL

2WD

Replace wheel hub as an assembly when replacing because sensor rotor cannot be disassembled. Refer to RAX-5, "Removal and Installation".

4WD

1. Remove drive shaft. Refer to RAX-17, "Removal and Installation".

2. Remove sensor rotor from drive shaft. Refer to RAX-21, "FINAL DRIVE SIDE : Disassembly and Assembly".

INSTALLATION

Note the following, and install in the reverse order of the removal.

• Never reuse sensor rotor. (4WD)

    Wheel sensor
    Front wheel sensor : Exploded View 1. Front LH wheel sensor 2. Front LH wheel sensor harness connector : Vehicle front : N·m (kg-m, in-lb) NOTE: Front RH wheel sensor is symmetrically opposi ...

    ABS actuator and electric unit (control unit)
    Exploded View LHD MR16DDT (2WD), HR16DE 1. ABS actuator and electric unit (control unit) 2. ABS actuator and electric unit (control unit) harness connector 3. Bracket A. To front LH caliper ...

    Other materials:

    Component parts
    CVT control system : Component Parts Location 1. Multi display unit (MDU)* Refer to DMS-3, "Component Parts Location". 2. Combination meter 3. S mode indicator (On the combination meter) 4. Shift position indicator (On the combination meter) 5. Malfunction indicator lamp (MIL) ( ...

    P1652 starter motor system COMM
    Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. Models with no Intelligent Key System transmit a control signal directly to IPDM E/R. On the other hand, models with the Intelligent Key System transmit a control signal to IPDM E/R by w ...

    P0471 exhaust gas pressure sensor 1
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0471 is displayed with DTC P0470 or P2226, first perform trouble diagnosis for DTC P0470 or P2226. Refer to EC-944, "DTC Logic" (P0470), EC-1002, "DTC Logic" (P2226). Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn i ...