Nissan Juke Service and Repair Manual : Work
• After removing and installing the opening/closing parts, be sure to carry out fitting adjustments to check their operational.
• Check the lubrication level, damage, and wear of each part. If necessary, grease or replace it.
Precaution for Procedure without Cowl Top Cover
When performing the procedure after removing cowl top cover, cover
the lower end of windshield with urethane, etc.
...
Preparation
Commercial Service Tools
...
Other materials:
Auto retractable door mirror does not operate
Diagnosis Procedure
1.CHECK INTELLIGENT KEY AND DOOR REQUEST SWITCH OPERATION
Check operation of Intelligent Key and door request switch.
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CHECK DOOR MIRROR (OPEN/CLOSE MOTOR) ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always us ...
C1144 incomplete steering angle sensor adjustment
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CON ...
