Nissan Juke Service and Repair Manual : Auto retractable door mirror does not operate

Diagnosis Procedure

1.CHECK INTELLIGENT KEY AND DOOR REQUEST SWITCH OPERATION

Check operation of Intelligent Key and door request switch.

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CHECK DOOR MIRROR (OPEN/CLOSE MOTOR) CIRCUIT

Check door mirror (open/close motor) circuit.

Refer to MIR-25, "Component Function Check".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CHECK AUTO RETRACTABLE DOOR MIRROR CIRCUIT

Check auto retractable door mirror circuit.

Refer to MIR-30, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CONFIRM THE OPERATION

Confirm the operation again.

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 1.

    Electric foldable door mirror does not operate
    Diagnosis Procedure 1.CHECK DOOR MIRROR (OPEN/CLOSE MOTOR) CIRCUIT Check door mirror (open/close motor) circuit. Refer to MIR-25, "Component Function Check". Is the inspection result ...

    Squeak and rattle trouble diagnoses
    Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the ...

    Other materials:

    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
    The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is include ...

    B2195 anti-scanning
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Refer to SEC-62, "Diagnosis Procedure". NO >> ...

    Both side headlamps (LO) are not turned on
    Description Both side headlamps (LO) are not turned ON in any condition. Diagnosis Procedure 1.CHECK COMBINATION SWITCH Check the combination switch. Refer to BCS-92, "Symptom Table". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfun ...