Nissan Juke Service and Repair Manual : B2013 steering lock unit

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Lock the steering.

NOTE

:

3. Press the push-button ignition switch.


3. Press the push-button ignition switch.

4. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-69, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM INITIALIZATION

Perform initialization of BCM and reregistration of all Intelligent Keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

Does steering lock operate? YES >> INSPECTION END

NO >> GO TO 2.

2.REPLACE STEERING LOCK UNIT

1. Replace steering lock unit.

2. Perform the service procedure for steering lock unit replacement. Refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

>> INSPECTION END

    B2198 nats antenna AMP.
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1 1. Contact Intelligent Key backside to push-button ignition switch. 2. Check DTC in “Self Diagn ...

    B2014 chain of STRG-IMMU
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Lock steering. NOTE: 3. Press the push-button ignition switch. 4. Check DTC in “Self Dia ...

    Other materials:

    The parking brake release warning continues sounding, or does not sound
    Description • The parking brake warning buzzer sounds continuously during vehicle travel though the parking brake is released. • The parking brake warning buzzer does not sound at all even though driving the vehicle with the parking brake applied. Diagnosis Procedure 1.CHECK PARKING BR ...

    Wiring diagram
    MANUAL HEATER SYSTEM Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

    Wheel Alignment
    2WD Measure value under unladen*2 conditions. *1: A difference when assuming the left side a standard. *2: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions. 4WD Measure value under unladen*2 conditions. *1: A differenc ...