Nissan Juke Service and Repair Manual : DTC/circuit diagnosis
- P1610 lock mode
- P1611 ID discord, IMMU-ECM
- P1612 chain of ECM-IMMU
- P1614 chain of IMMU-KEY
- P1616 ECM
- B2192 ID discord, IMMU-ECM
- B2193 chain of ECM-IMMU
- B2195 anti-scanning
- B2196 dongle unit
- B2198 nats antenna AMP.
- B2013 steering lock unit
- B2014 chain of STRG-IMMU
- B2555 stop lamp
- B2556 Push-button ignition switch
- B2557 vehicle speed
- B2601 shift position
- B2602 shift position
- B2603 shift position
- B2604 shift position
- B2605 shift position
- B2608 starter relay
- B2609 steering status
- B260B steering lock unit
- B260C steering lock unit
- B260F Engine status
- B2612 steering status
- B2619 BCM
- B261A Push-button ignition switch
- B261F ASCD clutch switch
- B2620 Park/neutral position switch
- B26E8 clutch interlock switch
- B26E9 steering status
- B26EF steering lock relay
- B26F0 steering lock relay
- B26F3 starter control relay
- B26F4 starter control relay
- B26F5 steering lock status switch
- B26F7 BCM
- B26F8 BCM
- B26F9 cranking request circuit
- B26FA cranking request circuit
- B26FB clutch switch
- B26FC key registration
- B209F cranking request circuit
- B20A0 cranking request circuit
- B2108 steering lock relay
- B2109 steering lock relay
- B210A steering lock unit
- B210B starter control relay
- B210C starter control relay
- B210D starter relay
- B210E starter relay
- B210F shift position/clutch interlock switch
- B2110 shift position/clutch interlock switch
- Hood switch
- Horn function
- Security indicator lamp
Additional service when replacing control unit
ECM
ECM : Description
Performing the following procedure can automatically activate recommunication
of ECM and BCM, but only
when the ECM is replaced with a new one*.
*: New one means a virgin ...
P1610 lock mode
Description
ECM forcibly switches to the mode that inhibits engine start, when engine
start operation is performed 5 times
or more while communication between ECM and BCM is not normal.
DTC Logic ...
Other materials:
Ignition signal
Component Function Check
1.INSPECTION START
Turn ignition switch OFF, and restart engine.
Does the engine start?
YES >> GO TO 2.
NO >> Proceed to EC-414, "Diagnosis Procedure".
2.IGNITION SIGNAL FUNCTION
With CONSULT-III
1. Perform “POWER BALANCE” in “ACTIVE ...
P0500 VSS
Description
The vehicle speed signal is sent to the combination meter from the “ABS
actuator and electric unit (control
unit)” by CAN communication line. The combination meter then sends a signal to
the ECM by CAN communication
line.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC P050 ...
P2138 APP sensor
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P2138 is displayed with DTC P0643, first perform the trouble diagnosis
for DTC P0643. Refer to
EC-686, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn
...
