Nissan Juke Service and Repair Manual : B26F7 BCM

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Press door request switch.

2. Turn ignition switch ON.

3. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-127, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Select “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC CONFIRMATION PROCEDURE for DTC B26F7. Refer to SEC-126, "DTC Logic".

Is DTC detected? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

>> INSPECTION END

    B26F5 steering lock status switch
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26F5 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26F5 is ...

    B26F8 BCM
    DTC Logic DTC DETECTION LOGIC NOTE: DTC B26F8 can be detected even though the related circuit is not used in this vehicle. DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. ...

    Other materials:

    P2138 APP sensor
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P2138 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643. Refer to EC-307, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform ...

    Battery terminal with fusible link
    Exploded View 1 : Battery terminal with fusible link 2 : Harness connector : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Disconnect the battery cable from the negative terminal. 2. Remove cover of battery positive terminal. 3. Remove harness mounting nut and battery terminal wit ...

    On board diagnostic (OBD) system
    Description This is an onboard diagnosis system which records diagnosis information related to the exhaust gases. It detects malfunctions related to sensors and actuators. The malfunctions are indicated by means of the malfunction indicator lamp (MIL) and are stored as DTC in the ECU memory. ...