Nissan Juke Service and Repair Manual : B26F8 BCM

DTC Logic

DTC DETECTION LOGIC

NOTE

:
DTC B26F8 can be detected even though the related circuit is not used in this vehicle.

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON and wait 1 second.

2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-127, "Diagnosis Procedure".

NO >> INSPECTION EN

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Select “Self Diagnostic Result” mode of ”BCM” using CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC CONFIRMATION PROCEDURE for DTC B26F8.

Refer to SEC-127, "DTC Logic".

Is DTC detected? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

>> INSPECTION END

    B26F7 BCM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press door request switch. 2. Turn ignition switch ON. 3. Check DTC in “Self Diagnostic Resul ...

    B26F9 cranking request circuit
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26F9 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26F9 is ...

    Other materials:

    Clock (if so equipped)
    The digital clock (in the audio unit) displays time when the ignition switch is in the ACC or ON position. The clock ON or OFF mode can be selected. For details of the digital clock in the NAVIGATION SYSTEM, refer to “Clock” . If the power supply is disconnected, the clock will not indicate ...

    P0841 transmission fluid pressure SEN/SW A
    Description Using the engine load (throttle position), the primary pulley revolution speed, and the secondary pulley revolution speed as input signal, TCM changes the operating pressure of the primary pulley and the secondary pulley and changes the groove width of the pulley to control the ge ...

    Floor mats
    WARNING To avoid potential pedal interference that may result in a collision or injury: • NEVER place a floor mat on top of another floor mat in the driver front position. • Use only genuine NISSAN floor mats specifically designed for use in your vehicle model. See your NISSAN dealer for ...