DTC Logic

DTC DETECTION LOGIC

NOTE

:
• If DTC B26FB is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic".

• If DTC B26FB is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-132, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Select “Self diagnostic result” mode of BCM using CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC Confirmation Procedure.

See SEC-132, "DTC Logic".

Is DTC detected? YES >> GO TO 2.

NO >> INSPECTION END

2.CHECK CLUTCH PEDAL POSITION SWITCH CIERCUIT

Refer to EC-427, "Component Function Check" (MR16DDT), EC-771, "Component Function Check" (HR16DE), or EC-980, "DTC Logic" (K9K).

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> INSPECTION END