Nissan Juke Service and Repair Manual : B26FC key registration

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Perform initialization of BCM and reregistration of all Intelligent Keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-133, "Diagnosis Procedure" NO >> INSPECTION END

Diagnosis Procedure

1.REPLACE INTELLIGENT KEY

1. Prepare Intelligent Key that matches the vehicle.

2. Perform initialization of BCM and registration of Intelligent Key using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

3. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

>> INSPECTION END

    B26FB clutch switch
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26FB is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26FB is ...

    B209F cranking request circuit
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC B209F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to PCS- 30, "DTC Logic". DTC CONFIRMATION PROC ...

    Other materials:

    I-LI system limitations
    WARNING The following points outline the critical operational boundaries and inherent limitations of the Intelligent Lane Intervention (I-LI) system. Failure to adhere strictly to these warnings and instructions regarding the proper and safe use of the I-LI system could lead to an unpredictable ...

    P0720 output speed sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. > ...

    Servicing air conditioner
    The air conditioner system in your NISSAN is charged with a refrigerant designed with the environment in mind. This refrigerant will not harm the earth’s ozone layer. Special charging equipment and lubricant are required when servicing your NISSAN air conditioner. Using improper refrigerants ...