Nissan Juke Service and Repair Manual : B26F4 starter control relay

DTC Logic

DTC DETECTION LOGIC

NOTE

:
• If DTC B26F4 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic".

• If DTC B26F4 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "DTC Logic".

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Press push-button ignition switch under the following conditions to start engine, and wait 1 second or more.

- Selector lever: In the P position - Brake pedal: Depressed 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-122, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK DTC OF IPDM E/R

Check DTC in “Self Diagnostic Result” mode of “IPDM E/R” using CONSULT-III.

Is DTC detected? YES >> Perform the diagnosis procedure related to the detected DTC. Refer to PCS-25, "DTC Index".

NO >> GO TO 2.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> INSPECTION END

    B26F3 starter control relay
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26F3 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26F3 is ...

    B26F5 steering lock status switch
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26F5 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26F5 is ...

    Other materials:

    Front wiper auto stop signal circuit
    Component Function Check 1.CHECK FRONT WIPER (AUTO STOP) SIGNAL CONSULT-III DATA MONITOR 1. Select “WIP AUTO STOP” of IPDM E/R data monitor item. 2. Operate the front wiper. 3. With the front wiper operation, check the monitor status. Is the status of item normal? YES >> Auto stop ...

    Diagnosis system (navi control unit)
    Diagnosis Description On-Board Diagnosis Item • On-board diagnosis is performed in service test mode. • On-board diagnosis checks if the system operates normally. Service test mode METHOD OF STARTING 1. Start the engine. 2. Turn OFF audio. 3. While pressing the “SET UP” switch, ...

    P0130 A/F sensor 1
    DTC Logic DTC DETECTION LOGIC To judge the malfunction, the diagnosis checks that the A/F signal computed by ECM from the A/F sensor 1 signal fluctuates according to fuel feedback control. DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conduc ...