Nissan Juke Service and Repair Manual : B2193 chain of ECM-IMMU

DTC Logic

DTC DETECTION LOGIC

NOTE

:
• If DTC B2193 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic".

• If DTC B2193 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "DTC Logic".

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-61, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

Can the system be initialized and can the engine be started with registered Intelligent Key? YES >> INSPECTION END

NO >> GO TO 2.

2.REPLACE ECM

Replace ECM.

Refer to EC-447, "Removal and Installation" (MR16DDT), or EC-805, "Removal and Installation" (HR16DE).

>> INSPECTION END

    B2192 ID discord, IMMU-ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CO ...

    B2195 anti-scanning
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CO ...

    Other materials:

    Draining
    WARNING: • Never remove radiator cap when engine is hot. Serious burns may occur from high-pressure engine coolant escaping from radiator. • Wrap a thick cloth around the radiator cap. Slowly turn it a quarter of a turn to release built-up pressure. Then turn it all the way. 1. Connec ...

    Thermo plunger unit
    Exploded View 1. Side member LH 2. Thermo plunger control unit 3. Thermo plunger relay 4. Thermo plunger connector 5. Earth lead 6. Thermo plunger unit 7. Bracket stay Vehicle front : N·m (kg-m, in-lb) Removal and Installation REMOVAL 1. Remove battery cable from the negative te ...

    Blower fan resistor
    Exploded View 1. A/C unit assembly 2. Blower fan resistor*1 3. Sub harness*1 4. Power transistor*2 5. Sub harness*2 6. Blower motor • *1: Manual air conditioner • *2: Automatic air conditioner Removal and Installation REMOVAL 1. Remove instrument panel assembly. Refer to IP-13, ...