Nissan Juke Service and Repair Manual : B2195 anti-scanning

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Refer to SEC-62, "Diagnosis Procedure".

NO >> INSPECTION END.

Diagnosis Procedure

1.CHECK SELF DIAGNOSTIC RESULT 1

1. Select “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

2. Erase DTC.

3. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to SEC-62, "DTC Logic".

Is DTC detected? YES >> GO TO 2.

NO >> INSPECTION END

2.CHECK EQUIPMENT OF THE VEHICLE

Check that unspecified accessory part related to engine start is not installed.

Is unspecified accessory part related to engine start installed? YES >> GO TO 3.

NO >> GO TO 4.

3.CHECK SELF DIAGNOSTIC RESULT 2

1. Obtain the customers approval to remove unspecified accessory part related to engine start, and then remove it.

2. Select “Self Diagnostic Result” of “BCM” using CONSULT-III.

3. Erase DTC.

4. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to SEC-62, "DTC Logic".

Is DTC detected? YES >> GO TO 4.

NO >> INSPECTION END

4.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

>> INSPECTION END

    B2193 chain of ECM-IMMU
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2193 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B2193 is ...

    B2196 dongle unit
    Description BCM performs ID verification between BCM and dongle unit. When verification result is OK, BCM permits cranking. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM ...

    Other materials:

    Tire labeling
    Federal law requires tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be ...

    P1726 throttle control signal
    Description Electric throttle control actuator consists of throttle control motor, accelerator pedal position sensor, throttle position sensor etc. The actuator sends a signal to the ECM, and ECM sends the signal to TCM with CAN communication. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATI ...

    Control linkage
    Exploded View 1. Bracket 2. Selector cable 3. Shifter lever A 4. Selector lever 5. Cable mounting bracket 6. Tapping bolt 7. Shifter cable 8. Grommet 9. M/T shift selector assembly 10. Shifter lever 11. Shifter lever knob : Always replace after every disassembly. : N·m (kg-m ...