Nissan Juke Service and Repair Manual : P1610 lock mode

Description

ECM forcibly switches to the mode that inhibits engine start, when engine start operation is performed 5 times or more while communication between ECM and BCM is not normal.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-52, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK ENGINE START FUNCTION

1. Check that DTC except for DTC P1610 is not detected.

If detected, erase the DTC after fixing.

2. Turn ignition switch OFF.

3. Contact the registered Intelligent Key backside to push-button ignition switch and wait 5 seconds.

4. Turn ignition switch ON.

5. Turn ignition switch OFF and wait 5 seconds.

6. Repeat steps 3 and 5 twice (a total of 3 times).

7. Check that engine can start.

>> INSPECTION END

    P1611 ID discord, IMMU-ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using ...

    Other materials:

    Rear wheel hub and housing
    Exploded View 1. Axle housing 2. Suspension arm 3. Back plate 4. Hub bolt 5. Wheel hub assembly (Bearing-integrated type) 6. Disc rotor 7. Plug 8. Wheel hub lock nut 9. Cotter pin : Always replace after every disassembly. : N·m (kg-m, ft-lb) Removal and Ins REMOVAL 1. Remove ...

    P1564 ASCD steering switch
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P1564 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605. Refer to EC-302, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform ...

    Air breather hose
    Removal and Installation REMOVAL 1. Remove air cleaner case. Refer to EM-26, "Removal and Installation". 2. Remove clip from bracket. 3. Remove air breather hose from transaxle assembly. INSTALLATION Note the following, and install in the reverse order of removal. CAUTION: Chec ...