Nissan Juke Service and Repair Manual : B260C steering lock unit

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Shift selector lever to the P position.

2. Press push-button ignition switch under the following condition.

- Brake pedal: Not depressed 3. Turn ignition switch ON.

4. Turn ignition switch OFF.

5. Press driver side door switch.

6. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-100, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Select “Self Diagnostic Result” mode of “BCM” using CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC Confirmation Procedure for DTC B260D. Refer to SEC-100, "DTC Logic".

Is DTC detected? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE STEERING LOCK UNIT

1. Replace steering lock unit.

2. Perform the service procedure for steering lock unit replacement. Refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

>> INSPECTION END

    B260B steering lock unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Turn ignition switch OFF. 3. Press driver side door switch. 4. Shi ...

    B260F Engine status
    Description BCM receives the engine status signal from ECM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B260F is displayed with DTC U1000, first perform the trouble diagn ...

    Other materials:

    Symptom diagnosis
    NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH troubleshooting Chart 1. Locate the area where noise occurs. 2. Confirm the type of noise. 3. Specify the operating condition of engine 4. Check specified noise source. If necessary, repair or replace these parts. A: Closely rela ...

    Rear disc brake
    Brake pad : Inspection and Adj INSPECTION Check brake pad wear thickness from an inspection hole on cylinder body. Check using a scale if necessary. Wear thickness : Refer to BR-137, "Rear Disc Brake". ADJUSTMENT Burnish contact surfaces between disc rotor and brake pads according ...

    Electrical load signal
    Description The electrical load signal (Headlamp switch signal, rear window defogger switch signal, etc.) is transferred via the CAN communication line. Component Function Check 1.CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION With CONSULT-III 1. Turn ignition switch ON. 2. Select “DATA MONIT ...