Nissan Juke Service and Repair Manual : P1612 chain of ECM-IMMU

DTC Logic

DTC DETECTION LOGIC

NOTE

:
• If DTC P1612 is displayed with DTC U1000 (for BCM), first perform the trouble diagnosis for DTC U1000.

Refer to BCS-83, "DTC Logic".

• If DTC P1612 is displayed with DTC U1010 (for BCM), first perform the trouble diagnosis for DTC U1010.

Refer to BCS-84, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-54, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.

For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.

Can the system be initialized and can the engine be started with registered Intelligent Key? YES >> INSPECTION END

NO >> GO TO 2.

2.REPLACE ECM

Replace ECM.

Refer to EC-447, "Removal and Installation" (MR16DDT), or EC-805, "Removal and Installation" (HR16DE).

>> INSPECTION END

    P1611 ID discord, IMMU-ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using ...

    P1614 chain of IMMU-KEY
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1 1. Contact Intelligent Key backside to push-button ignition switch. 2. Check DTC in “Self Diagn ...

    Other materials:

    Garage Jack and Safety Stand and 2-Pole Lift
    WARNING: • Park the vehicle on a level surface when using the jack. Check to avoid damaging pipes, tubes, etc. under the vehicle. • Never get under the vehicle while it is supported only by the jack. Always use safety stands when you have to get under the vehicle. • Place wheel choc ...

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1.CHECK POWER WINDOW AUTO OPERATION Check AUTO operation when anti-pinch function does not operate. Is the inspection result normal? YES >> GO TO 2. NO >> Refer to PWC-41, "Diagnosis Procedure". 2.CONFIRM THE OPERATION Confirm the operation agai ...

    Unbalance steering wheel turning force and return between right and left
    Description Unbalance steering wheel turning force and return between right and left. Diagnosis Procedure 1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP Check the EPS warning lamp while engine is running. Does the EPS warning lamp turn OFF? YES >> GO TO 2. NO >> Refer to STC ...