Nissan Juke Service and Repair Manual : P1616 ECM

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION

1. Turn ignition switch ON amd wait 2 seconds or more.

2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.

Is DTC detected? YES >> Go to SEC-199, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Select “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC CONFIRMATION PROCEDURE for DTC P1616. Refer to SEC-199, "DTC Logic".

Is DTC P1616 displayed again? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE ECM

Replace ECM.

>> INSPECTION END

    P1614 chain of IMMU-KEY
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1 1. Contact Intelligent Key backside to push-button ignition switch. 2. Check DTC in “Self Diagn ...

    B2192 ID discord, IMMU-ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CO ...

    Other materials:

    Push-button ignition switch does not operate
    Description Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom. NOTE: The engine start function, door lock function, power distribution system, and NATS-IVIS/NVIS in the Intelligent Key system are closely relate ...

    Intelligent Lane Intervention (I-LI)
    WARNING Failure to strictly follow the safety warnings and operational instructions for the proper use of the I-LI system could result in an unintended vehicle path, loss of control, and subsequent serious injury or death. The I-LI system is a driver-assist ...

    System
    Can communication system CAN COMMUNICATION SYSTEM : System Diagram CAN COMMUNICATION SYSTEM : System Description Description • CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communicat ...