Nissan Juke Service and Repair Manual : Auto door lock operation does not operate

Nissan Juke Service and Repair Manual / Door & Lock type 2 / Symptom diagnosis / Auto door lock operation does not operate

Diagnosis Procedure

1.CHECK “AUTO LOCK SET” SETTING IN “WORK SUPPORT”

1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.

2. Select “AUTO LOCK SET” in “WORK SUPPORT” mode.

3. Check “AUTO LOCK SET” in “WORK SUPPORT”.

Refer to DLK-219, "INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY) (Without Super Lock)".

Is the inspection result normal? YES >> GO TO 2.

NO >> Set “AUTO LOCK SET” setting in “WORK SUPPORT”.

2.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Back door does not opened
    Diagnosis Procedure 1.CHECK BACK DOOR OPENER SWITCH Check back door opener switch. Refer to DLK-244, "Component Function Check". Is the inspection result normal? YES >> GO TO ...

    Vehicle speed sensing auto lock operation does not operate
    Diagnosis Procedure 1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “AUTOMATIC LOCK/UNLOCK SELECT” i ...

    Other materials:

    Refrigerant pressure sensor
    Component Function Check 1.CHECK REFRIGERANT PRESSURE SENSOR OVERALL FUNCTION 1. Start engine and warm it up to normal operating temperature. 2. Turn A/C switch and blower fan switch ON. 3. Check the voltage between ECM harness connector and ground. Is the inspection result normal? YES >& ...

    Appearance and care
    Removing spots To preserve the pristine finish of your Nissan Leaf, it is essential to remove stubborn contaminants such as road tar, oil splatters, industrial fallout, insect residue, and tree sap as promptly as possible. If left to sit, these substances can chemically bond with or etch the pa ...

    P0078 EVT control solenoid valve
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...