Nissan Juke Service and Repair Manual : Back door does not opened

Diagnosis Procedure

1.CHECK BACK DOOR OPENER SWITCH

Check back door opener switch.

Refer to DLK-244, "Component Function Check".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CHECK BACK DOOR OPENER ACTUATOR

Check back door opener actuator.

Refer to DLK-242, "Component Function Check".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CHECK VEHICLE SPEED SIGNAL

Check vehicle speed signal.

Refer to MWI-36, "DTC Index".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CONFIRM THE OPERATION

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    ANTI-HIJACK function does not operate
    Diagnosis Procedure 1.CHECK “DOOR LOCK–UNLOCK SET” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK-UNLOCK SET” in “WORK SUPP ...

    Auto door lock operation does not operate
    Diagnosis Procedure 1.CHECK “AUTO LOCK SET” SETTING IN “WORK SUPPORT” 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “AUTO LOCK SET” in “WORK SUPPORT” mod ...

    Other materials:

    ASCD main switch
    Component Function Check 1.CHECK ASCD MAIN SWITCH FUNCTION With CONSULT-III 1. Turn ignition switch ON. 2. Select “ENGINE” using CONSULT-III. 3. Select “MAIN SW” in “DATA MONITOR” mode. 4. Check “MAIN SW” indication under the following condition. Without CONSULT-III 1. Turn ...

    Radio frequency statement
    For USA This device complies with Part 15 of the FCC Rules. Its operation is subject to the following two conditions: 1. This device must not cause harmful interference; and 2. This device must accept any interference received, including any interference that may potentially cause und ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always us ...