Unlock sensor

Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “UNLK SEN -DR” in “DATA MONITOR” mode. 3. Check that the function operates normally acco ...

Door does not lock/unlock with door request switch

All door request switches ALL DOOR REQUEST SWITCHES : Description All doors do not lock/unlock using all door request switches. ALL DOOR REQUEST SWITCHES : Diagnosis Procedure 1.CHECK REMOTE KEYLE ...

Other materials:

B2190 nats antenna AMP
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Refer to SEC-200, "Diagnosis Procedure". NO >&g ...

Parts Requiring Angle Tightening
• Use the angle wrench [SST: KV10112100] for the final tightening of the following engine parts: - Camshaft sprocket (INT) bolt - Cylinder head bolts - Main bearing cap bolts - Connecting rod cap bolts - Crankshaft pulley bolt (No the angle wrench is required as bolt flange is provided with ...

B1026, B1027, B1028, B1029, B1030, B1031 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...