Nissan Juke Service and Repair Manual : Intelligent key low battery warning does not operate

Nissan Juke Service and Repair Manual / Door & Lock type 2 / Symptom diagnosis / Intelligent key low battery warning does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM AND COMBINATION METER

Check that DTC is not detected with BCM and combination meter.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index". (Combination meter)

2.CHECK “LO- BATT OF KEY FOB WARN” SETTING IN “WORK SUPPORT”

1. Select “INTELLIGENT KEY” of “BCM”.

2. Select “LO- BATT OF KEY FOB WARN” in “WORK SUPPORT” mode.

3. Check “LO- BATT OF KEY FOB WARN” in “WORK SUPPORT”.

Refer to DLK-219, "INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY) (Without Super Lock)".

Is the inspection result normal? YES >> GO TO 3.

NO >> Set “LO- BATT OF KEY FOB WARN” in “WORK SUPPORT”.

3.CHECK KEY WARNING LAMP

Check key warning lamp.

Refer to DLK-265, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK INTELLIGENT KEY

Check Intelligent key.

Refer to DLK-262, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.CHECK INSIDE KEY ANTENNA

Check inside key antenna.

• Instrument center: Refer to DLK-230, "DTC Logic".

• Console: Refer to DLK-232, "DTC Logic".

• Luggage room: Refer to DLK-234, "DTC Logic".

Is the inspection result normal? YES >> GO TO 6.

NO >> Repair or replace the malfunctioning parts.

6.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Take away warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >& ...

    Door lock operation warning does not operate
    Diagnosis Procedure 1.CHECK DOOR LOCK FUNCTION Check door lock function. Does door lock/unlock using door request switch? YES >> GO TO 2. NO >> Refer to DLK-256, "Component F ...

    Other materials:

    Unlock sensor
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “LOCK STATUS” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Unlock sensor is OK. ...

    Intelligent key battery
    Removal and Installation 1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key. 2. Insert a flat-blade screwdriver (A) wrapped with a cloth into the slit of the corner and twist it to separate the upper part from the lower part. CAUTION: • Do not touch t ...

    Body component parts
    Underbody Component Parts (2WD Models) : Both sided anti-corrosive precoated steel sections : High strength steel (HSS) sections : Both sided anti-corrosive steel and HSS sections NOTE: • For the parts without a number described in the figure, it is supplied only with the assembly p ...