Nissan Juke Service and Repair Manual : Take away warning does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM AND COMBINATION METER

Check that DTC is not detected with BCM and combination meter.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index". (Combination meter)

2.CHECK COMBINATION METER BUZZER

Check combination meter buzzer.

Refer to WCS-40, "Component Function Check".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CHECK KEY WARNING LAMP

Check key warning lamp.

Refer to DLK-265, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK DOOR SWITCH

Check door switch.

Refer to DLK-258, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.CHECK INTELLIGENT KEY WARNING BUZZER

Check Intelligent Key warning buzzer.

Refer to DLK-263, "Component Function Check".

Is the inspection result normal? YES >> GO TO 6.

NO >> Repair or replace the malfunctioning parts.

6.CHECK INSIDE KEY ANTENNA

Check inside key antenna.

• Instrument center: Refer to DLK-230, "DTC Logic".

• Console: Refer to DLK-232, "DTC Logic".

• Luggage room: Refer to DLK-234, "DTC Logic".

Is the inspection result normal? YES >> GO TO 7.

NO >> Repair or replace the malfunctioning parts.

7.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    ACC warning does not operate
    Diagnosis Procedure 1.CHECK COMBINATION METER BUZZER Check combination meter buzzer. Refer to WCS-40, "Component Function Check". Is the inspection result normal? YES >> GO TO ...

    Intelligent key low battery warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >& ...

    Other materials:

    Security indicator lamp does not turn on or blink
    Description Security indicator lamp does not blink when ignition switch is in a position other than ON. NOTE: • Before performing the diagnosis, check “Work Flow”. Refer to SEC-187, "Work Flow". • Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE ...

    P1739 1GR incorrect ratio
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: • Be sure to perform “TM-442, "Diagnosis Procedure"” and then perform “DTC CONFIRMATION PROCEDURE”. • Never perform "DTC CONFIRMATION PROCEDURE" before the repairs. Doing so may result in a s ...

    Diagnosis system (A/C auto AMP.)
    Description Air conditioning system performs self-diagnosis, operation check, function diagnosis, and various settings using diagnosis function of each control unit. CONSULT-III Function CONSULT-III performs the following functions via CAN communication with A/C auto amp. NOTE: Diagnos ...