Nissan Juke Owners Manual : Break-in schedule
CAUTION
During the first 1,200 miles (2,000 km), follow these recommendations to obtain maximum engine performance and ensure the future reliability and economy of your new vehicle. Failure to follow these recommendations may result in shortened engine life and reduced engine performance.
• Avoid driving for long periods at constant speed, either fast or slow. Do not run the engine over 4,000 rpm.
• Do not accelerate at full throttle in any gear.
• Avoid quick starts.
• Avoid hard braking as much as possible.
Cruise control operations
1. ACCEL/RES switch
2. COAST/SET switch
3. CANCEL switch
4. MAIN (ON·OFF) switch
The cruise control allows driving at a speed between 25 to 89 MPH (40 to 144
km/h) without keeping your foot on ...
Fuel Efficient Driving Tips
Follow these easy-to-use Fuel Efficient Driving Tips to help you achieve the
most fuel economy from your vehicle.
1. Use smooth accelerator and brake pedal application.
• Avoid rapid starts ...
Other materials:
P1550 battery current sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following before conducting
the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. ...
Steering switch signal B circuit
Description
Transmits the steering switch signal to audio unit.
Diagnosis Procedure
1.CHECK STEERING SWITCH SIGNAL B CIRCUIT
1. Disconnect audio unit connector and spiral cable connector.
2. Check continuity between audio unit harness connector and spiral cable
harness connector.
3. Check ...
4WD mode indicator lamp (4WD-V)
Component Function Check
1.4WD MODE INDICATOR LAMP OPERATION CHECK
1. Turn the ignition switch ON.
2. Change 4WD mode switch to “4WD-V”.
3. Check that 4WD mode indicator lamp (4WD-V) turns on.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Proceed to diagnosis proc ...
