Nissan Juke Service and Repair Manual : Vehicle Recovery (Freeing a Stuck Vehicle)

Nissan Juke Service and Repair Manual / General information / Tow truck towing / Vehicle Recovery (Freeing a Stuck Vehicle)

FRONT
1. Remove the hook cover from the bumper using a remover tool.

2. Securely install the vehicle recovery hook stored with jacking tools.

Check that the hook is properly secured in the stored place after use.

WARNING:
• Stand clear of a stuck vehicle.

• Never spin your tires at high speed. This could cause them to explode and result in serious injury. Parts of your vehicle could also overheat and be damaged.

CAUTION:
• Tow chains or cables must be attached only to the vehicle recovery hooks or main structural members of the vehicle.

Otherwise, the vehicle body will be damaged.

• Never use the vehicle tie downs to free a vehicle stuck in sand, snow, mud, etc. Never tow the vehicle using the vehicle tie downs or recovery hooks.

• Always pull the cable straight out from the front of the vehicle. Never pull on the hook at an angle.

• Pulling devices should be routed so they do not touch any part of the suspension, steering, brake or cooling systems.

• Pulling devices such as ropes or canvas straps are not recommended for use in vehicle towing or recovery.

REAR


REAR

Securely install the vehicle recovery hook stored with jacking tools.

• 2WD

• 4WD


• 4WD

Basic inspection


    Tow Truck Towing
    CAUTION: • All applicable state or Provincial laws and local laws regarding the towing operation must be obeyed. • It is necessary to use proper towing equipment to avoid possible damage to t ...

    Other materials:

    Rear-facing child restraint installation using the seat belts
    WARNING You must utilize the three-point seat belt equipped with an Automatic Locking Retractor (ALR) when securing a child restraint. Failing to properly engage the ALR mode means the child restraint will not be secured effectively. This can allow the restraint to tip over or shift during ...

    Front drive shaft
    Exploded View LEFT SIDE 1. Circular clip 2. Dust shield 3. Housing assembly 4. Boot band 5. Boot 6. Damper band 7. Dynamic damper 8. Circular clip 9. Joint sub-assembly : Wheel side : Fill NISSAN Genuine grease or equivalent. : Always replace after every disassembly. RIGHT ...

    Back door request switch
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “REQ SW-BD/TR” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >&g ...