Nissan Juke Service and Repair Manual : General information
- How to use this manual
- How to follow trouble diagnoses
- Description
- How to Follow Test Groups in Trouble Diagnosis
- Key to Symbols Signifying Measurements or Procedures
- How to read wiring diagrams
- Connector Symbols
- Sample/Wiring Diagram -Example-
- Connector Information/Explanation of Option Abbreviation
- Abbreviations
- Tightening torque of standard bolts
- Vehicle information
- Precautions
- Description
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Precaution for Procedure without Cowl Top Cover
- General Precautions
- Three Way Catalyst
- Multiport Fuel Injection System or Engine Control System
- Turbocharger (If Equipped)
- Hoses
- Engine Oils
- Air Conditioning
- Fuel
- Lifting point
- Tow truck towing
- Basic inspection
Foreword
This manual contains maintenance and repair procedures for the NISSAN
JUKE, model F15 series.
In order to assure your safety and the efficient functioning of the vehicle,
this manual should be re ...
Other materials:
G sensor calibration
Description
TCM stores calibration data (inherent characteristic value) of G sensor to
provide accurate control. Therefore,
it is required to perform calibration of G sensor after the following work is
performed.
• Removal/installation or replacement of G sensor
• Replacement of TCM
Proce ...
Checking engine oil level
1. Park the vehicle on a level surface and apply the parking brake.
2. Run the engine until it reaches operating temperature.
3. Turn off the engine. Wait more than 10 minutes for the oil to drain back into
the oil pan.
4. Remove the dipstick and wipe it clean.
Reinsert it all the way.
5. R ...
B1050, B1055 driver air bag module
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
