Nissan Juke Service and Repair Manual : Description

NOTICE

:

Trouble diagnoses indicate work procedures required to diagnose problems effectively. Observe the following instructions before diagnosing.

• Before performing trouble diagnoses, read the “Work Flow” in each section.

• After repairs, re-check that the problem has been completely eliminated.

• Refer to Component Parts and Harness Connector Location for the Systems described in each section for identification/location of components and harness connectors.

• When checking circuit continuity, ignition switch should be OFF.

• Refer to the Circuit Diagram for quick pinpoint check.

If you need to check circuit continuity between harness connectors in more detail, such as when a sub-harness is used, refer to Wiring Diagram in each individual section and Harness Layout in PG section for identification of harness connectors.

• Before checking voltage at connectors, check battery voltage.

• After accomplishing the Diagnosis Procedures and Electrical Components Inspection, check that all harness connectors are reconnected as they were.

    How to Follow Test Groups in Trouble Diagnosis
    1. Test group number and test group title • Test group number and test group title are shown in the upper portion of each test group. 2. Work and diagnosis procedure • Start to diagnose a ...

    Other materials:

    Component parts
    Component Part Location 1. BCM • With Intelligent Key: Refer to BCS- 6, "BODY CONTROL SYSTEM : Component Parts Location". • Without Intelligent Key: Refer to BCS-96, "BODY CONTROL SYSTEM : Component Parts Location". 2. Magnet clutch 3. Refrigerant pressure sensor ...

    Rear door
    Exploded View 1. Rear door panel 2. TORX bolt 3. Door striker 4. Door check link 5. Door hinge (lower) 6. Door hinge (upper) : Do not reuse : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) : Body grease Door assembly DOOR ASSEMBLY : Removal and Installation CAUTION: • Perform work wit ...

    P0725 engine speed
    Description The engine speed signal is transmitted from ECM to TCM by CAN communication line. DTC Logic DTC DETECTION LOGI DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn igni ...