Nissan Juke Service and Repair Manual : Engine idle speed too high

Description

CHART 5: ENGINE IDLE SPEED TOO HIGH

Diagnosis Procedure

1.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT

Check ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace harness or connector.

2.CHECK WIRING HARNESS

Visually check the condition of the engine wiring harness.

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace harness or connector.

3.CHECK ACCELERATOR PEDAL POSITION SENSOR

Check the accelerator pedal position sensor. Refer to EC-1001, "Component Inspection".

Is the inspection result normal? YES >> INSPECTION END

NO >> Repair or replace.

    Impossible to shut off engine
    Description CHART 4: IMPOSSIBLE TO SHUT OFF ENGINE Diagnosis Procedure 1.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT Check ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Pro ...

    Engine idle speed too low or unstable
    Description CHART 6: ENGINE IDLE SPEED TOO LOW OR UNSTABLE Diagnosis Procedure 1.CHECK FUEL Check that the fuel reservoir is correctly filled and with the right fuel. >> GO TO 2. 2.CHE ...

    Other materials:

    C1105, C1106, C1107, C1108 wheel sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSU ...

    Front seat (4WD)
    Exploded View DRIVER SEAT LHD models 1. Headrest 2. Headrest holder (locked) 3. Headrest holder (free) 4. Seatback assembly (with heater seat only) 5. Inner lower cover 6. Seatback trim (without heater seat only) 7. Seatback pad (without heater seat only) 8. Seat belt buckle 9. A ...

    Component parts
    CVT control system : Component Parts Location 1. Multi display unit (MDU)* Refer to DMS-3, "Component Parts Location". 2. Combination meter 3. S mode indicator (On the combination meter) 4. Shift position indicator (On the combination meter) 5. Malfunction indicator lamp (MIL) ( ...