Nissan Juke Service and Repair Manual : Symptom diagnosis
- Engine control system symptoms
- Not communication with the ECM
- Engine does not start or starts with difficulty
- Starting difficult with cold engine
- Impossible to shut off engine
- Engine idle speed too high
- Engine idle speed too low or unstable
- Engine stalling
- No or very little acceleration, increase in engine speed
- Engine bucking
- Erratic acceleration
- No engine braking
- Loss of power
- Too much power
- Overspeed at idle speed or on releasing brake
- Excessive consumption
- Engine knock
- Engine overheating
- Engine smokes when started
- Engine emits blue smoke
- Engine smokes when revved
- Engine emits white smoke (especially when starting)
- Emission control not satisfactory
Speed limiter main switch
Component Function Check
1.CHECK SPEED LIMITER MAIN SWITCH FUNCTION
1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector terminals under the following
conditions
Is t ...
Engine control system symptoms
Symptom Table
NOTE:
Only consult this customer complaint after a complete check using the
CONSULT-III.
...
Other materials:
Intelligent Lane Intervention (I-LI)
WARNING
Failure to strictly follow the safety warnings and operational instructions for the proper use of the I-LI system could result in an unintended vehicle path, loss of control, and subsequent serious injury or death.
The I-LI system is a driver-assist ...
BCM
LHD
LHD : Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
P2135 TP sensor
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P2135 is displayed with DTC P0643, first perform the trouble diagnosis
for DTC P0643. Refer to
EC-686, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn
...
