Nissan Juke Service and Repair Manual : Engine smokes when started

Description

CHART 18: ENGINE SMOKES WHEN STARTED

Diagnosis Procedure

1.CHECK ENGINE OIL

Check the grade of engine oil. Refer to LU-33, "Inspection".

Is the inspection result normal? YES >> GO TO 2.

NO >> Replace engine oil. Refer to LU-34, "Refilling".

2.CHECK ENGINE OIL LEVEL

Is the engine oil level correct? Yes or No Yes >> GO TO 3.

No >> Top up the oil.

3.CHECK FUEL TEMPERATURE SENSOR

Check fuel temperature sensor. Refer to EC-916, "Component Inspection".

Is the inspection result normal? Yes >> GO TO 4.

No >> Repair or replace.

4.CHECK ENGINE COOLANT TEMPERATURE SENSOR

Check engine coolant temperature sensor. Refer to EC-908, "Component Inspection".

Is the inspection result normal? Yes >> GO TO 5.

No >> Repair or replace.

5.CHECK COOLING SYSTEM

Check the cooling system. Refer to CO-60, "Troubleshooting Chart".

Is the inspection result normal? YES >> GO TO 6.

NO >> Repair or replace.

6.CHECK HIGH PRESSURE SUPPLY PUMP (PRESSURE CONTROL VALVE)

Perform the TEST 3: HIGH PRESSURE SUPPLY PUMP (PRESSURE CONTROL VALVE). Refer to EC-868, "Work Procedure [TEST 3: High Pressure Supply Pump (Pressure Control Valve) Check]".

>> GO TO 7.

7.CHECK HIGH PRESSURE SUPPLY PUMP (VOLUMETRIC CONTROL VALVE)

Perform the TEST 4: HIGH PRESSURE SUPPLY PUMP (VOLUMETRIC CONTROL VALVE). Refer to EC- 869, "Work Procedure [TEST 4: High Pressure Supply Pump (Volumetric Control Valve) Check]".

>> GO TO 8.

8.CHECK RAIL HIGH PRESSURE CONTROL CIRCUIT

Perform the TEST 5: RAIL HIGH PRESSURE CONTROL CIRCUIT CHECK. Refer to EC-871, "Work Procedure (TEST 5: Rail High Pressure Regulation Check)".

>> INSPECTION END

    Engine overheating
    Description CHART 17: ENGINE OVERHEATING Diagnosis Procedure 1.CHECK COOLING SYSTEM Check the cooling system. Refer to CO-60, "Troubleshooting Chart". Is the inspection result normal? ...

    Engine emits blue smoke
    Description CHART 19: ENGINE EMITS BLUE SMOKE Diagnosis Procedure 1.CHECK ENGINE OIL Check the grade of engine oil. Refer to LU-33, "Inspection". Is the inspection result normal? YES ...

    Other materials:

    DPF (diesel particulate filter) data clear
    Description Perform ???DIESEL PARTICULATE FILTER DATA CLEAR??? in ???WORK SUPPORT??? mode with CONSULT-III when oxidation catalyst with diesel particulate filter is replaced as new one. Based on the signal from sensors ECM estimates the amount of particulate matter in diesel particulate filte ...

    ABS actuator and electric unit (control unit)
    Exploded View LHD MR16DDT (2WD), HR16DE 1. ABS actuator and electric unit (control unit) 2. ABS actuator and electric unit (control unit) harness connector 3. Bracket A. To front LH caliper B. To rear RH caliper C. To rear LH caliper D. To front RH caliper E. To master cylinder seco ...

    Both side front fog lamps are not turned on
    Description The front fog lamps are not turned ON in any condition. Diagnosis Procedure 1.CHECK FUSE Check that the following fuse is fusing. Is the inspection result normal? YES >> GO TO 2. NO >> Repair the applicable circuit. And then replace the fuse. 2.COMBINATION SWITC ...