Nissan Juke Service and Repair Manual : Engine control system symptoms
Symptom Table
NOTE
:
Only consult this customer complaint after a complete check using the
CONSULT-III.
Not communication with the ECM
Description
CHART 1: NO COMMUNICATION WITH THE ECM
Diagnosis Procedure
1.INSPECTION START
Ensure that CONSULT-III is not causing the malfunction by trying to establish
dialogue with an ECM on
a ...
Other materials:
Service
• Never use electrical test equipment to check SRS circuits unless instructed
to in this Service Manual.
• Before servicing the SRS, turn ignition switch OFF, disconnect battery
negative terminal and wait at least 3
minutes.
For approximately 3 minutes after the battery negative termina ...
P0190 FRP sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
Reporting safety defects
For USA
If you suspect that your Nissan Leaf possesses a safety-related defect that could potentially result in a collision, injury, or death, it is imperative that you notify the National Highway Traffic Safety Administration (NHTSA) immediately, in addition to reporting your concerns directly ...
