Nissan Juke Service and Repair Manual : Handling for Adhesive and Primer
• Never use an adhesive that is past its usable date. Shelf life of this product is limited to six months after the date of manufacture. Carefully adhere to the expiration or manufacture date printed on the box.
• Keep primers and adhesive in a cool, dry place. Ideally, they should be stored in a refrigerator.
• Open the seal of the primer and adhesive just before application. Discard the remainder.
• Before application, be sure to shake the primer container to stir the contents. If any floating material is found, do not use it.
• If any primer or adhesive contacts the skin, wipe it off with gasoline or an equivalent and wash the skin with soap.
• When using primer and adhesive, always observe the precautions in the instruction manual.
Precaution for Procedure without Cowl Top Cover
When performing the procedure after removing cowl top cover, cover
the lower end of windshield with urethane, etc.
...
Preparation
Commercial Service Tools
...
Other materials:
RAB system operation
RAB warning light and dedicated system warning indicator
Steering-wheel-mounted control switches (located on the left side)
Center infotainment and information display
The RAB system is active whenever the shift lever is placed in the R (R ...
P0488 EGR system
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK EGR VOLUME CONTROL VALVE CONTROL CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect EGR volume control valve harness connector and ECM harness
connector.
3. Check the continuity between EGR volume control valve terminal harness
co ...
Key positions
LOCK (0)
The key can only be removed from the ignition switch at this position.
OFF (1)
The engine is turned off. The power supply is turned off.
ACC (2)
The electrical accessory power activates without the engine turned on.
ON (3)
The ignition system and the electrical accessory power activa ...
