Nissan Juke Owners Manual : Key positions
LOCK (0)
The key can only be removed from the ignition switch at this position.
OFF (1)
The engine is turned off. The power supply is turned off.
ACC (2)
The electrical accessory power activates without the engine turned on.
ON (3)
The ignition system and the electrical accessory power activate without the engine turned on.
START (4)
The engine starter activates and the engine will start. The ignition switch, when released, will automatically turn to the ON position.
CAUTION
As soon as the engine has started, release the ignition switch immediately.
Manual Transmission (MT)
The ignition switch includes a device that helps prevent accidental removal of
the key while driving.
The key can only be removed when the ignition switch is in the LOCK position.
To turn the ig ...
Push-button ignition switch (models with Intelligent Key system)
WARNING
Do not operate the push-button ignition switch while driving the vehicle except
in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive
times or the igniti ...
Other materials:
Back door opener switch
Component Function Check
1.CHECK FUNCTION
1. Select “TRUNK” of “BCM” using CONSULT-III.
2. Select “TRNK OPNR SW” in “DATA MONITOR” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Back do ...
P158A ECM
DTC Logic
*: Since this DTC is detected when G sensor calibration is incomplete, there
is not replacement parts.
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition swit ...
I-FCW system limitations
WARNING
The following list details the specific operating limitations of the I-FCW system. Failure to operate your Nissan Leaf while mindful of these technical boundaries could lead to a failure in system alerts and result in serious injury or death.
...
