Nissan Juke Owners Manual : Starting and driving
- Precautions when starting and driving
- Exhaust gas (carbon monoxide)
- Three-way catalyst
- Tire Pressure Monitoring System (TPMS)
- Avoiding collision and rollover
- Off-road recovery
- Rapid air pressure loss
- Drinking alcohol/drugs and driving
- Driving safety precautions
- Ignition switch (models without Intelligent Key system)
- Push-button ignition switch (models with Intelligent Key system)
- Operating range for engine start function
- Push-button ignition switch operation
- Push-button ignition switch positions
- Emergency engine shut off
- Intelligent Key battery discharge
- Before starting the engine
- Starting the engine
- Driving the vehicle
- Integrated control system (if so equipped)
- Parking brake
- Cruise control
- Break-in schedule
- Fuel Efficient Driving Tips
- Increasing fuel economy
- All-Wheel Drive (AWD) (if so equipped)
- Parking/parking on hills
- Electric power steering system
- Brake system
- Brake assist
- Vehicle Dynamic Control (VDC) system
- Cold weather driving
Troubleshooting guide
The system should respond correctly to all voice commands without difficulty.
If problems are encountered, try the following solutions.
Where the solutions are listed by number, try each solution i ...
Precautions when starting and driving
WARNING
• Do not leave children or adults who would normally require the support
of others alone in your vehicle. Pets should not be left alone either. They could
accidentally injure themse ...
Other materials:
LAN System can system (type 10)
DTC/CIRCUIT DIAGNOSIS
Main line between IPDM-E and DLC circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (connector s ...
Input shaft and gear
Exploded View
1. Input shaft front bearing
2. Input shaft
3. 3rd input gear
4. Spacer
5. Snap ring
6. 3rd baulk ring
7. 3rd-4th coupling sleeve
8. 3rd-4th synchronizer hub
9. Insert key
10. 4th baulk ring
11. 4th input gear
12. 5th input gear
13. 5th baulk ring
14. 5th-6th c ...
Diagnosis and repair work flow
Work Flow
DETAILED FLOW
1.INTERVIEW FROM THE CUSTOMER
Clarify customer complaints before inspection. First of all, perform an
interview utilizing BRC-146, "Diagnostic
Work Sheet" and reproduce the symptom as well as fully understand it. Ask
customer about his/her complaints
carefu ...
