Nissan Juke Owners Manual : Troubleshooting guide

The system should respond correctly to all voice commands without difficulty. If problems are encountered, try the following solutions.

Where the solutions are listed by number, try each solution in turn, starting with number 1, until the problem is resolved.

Starting and driving


    Speaker Adaptation (SA) mode
    Speaker Adaptation allows up to two out-of dialect users to train the system to improve recognition accuracy. By repeating a number of commands, the users can create a voice model of their own voi ...

    Other materials:

    B2636, B2637, B2638, B2639, B2654, B2655 mode door motor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE With CONSULT-III 1. Turn ignition switch ON. 2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III. 3. Check DTC. Is DTC detected? YES >> Refer to HAC-157, "Diagnosis P ...

    Removal and Disassembly
    • When instructed to use SST, use specified tools. Always be careful to work safely, avoid forceful or uninstructed operations. • Exercise maximum care to avoid damage to mating or sliding surfaces. • Dowel pins are used for several parts alignment. When replacing and reassembling parts with ...

    G sensor calibration
    Description TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed. • Removal/installation or replacement of G sensor • Replacement of TCM Proce ...