Models with Intelligent Key system

1. Apply the parking brake. 2. Move the shift lever to the P (Park) or N (Neutral) position. (P is recommended.) The starter is designed not to operate unless the shift lever is in either of the ...

Continuously Variable Transmission (CVT)

The Continuously Variable Transmission (CVT) in your vehicle is electronically controlled to produce maximum power and smooth operation. The recommended operating procedures for this transmission a ...

Other materials:

Precautions for Drive Shaft
• Observe the following precautions when disassembling and assembling drive shaft. - Never disassemble joint sub-assembly because it is non-overhaul parts. - Perform work in a location which is as dust-free as possible. - Clean the parts, before disassembling and assembling. - Prevent the ...

For frontal collision : When SRS is activated in a collision
CAUTION: Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles. WORK PROCEDURE 1. Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed. 2. Replace the diagnosis sensor unit. ...

P0603 ECM power supply
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...