Nissan Juke Service and Repair Manual : B1218, B1219, B1220, B1221, B1222, B1223 diagnosis sensor unit

Nissan Juke Service and Repair Manual / SRS Airbag Control System / DTC/circuit diagnosis / B1218, B1219, B1220, B1221, B1222, B1223 diagnosis sensor unit

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.CHECK SELF-DIAG RESULT

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.

1. Turn ignition switch ON.Without CONSULT-III


1. Turn ignition switch ON.

2. Check the air bag warning lamp status. Refer to SRC-12, "On Board Diagnosis Function".

NOTE

:
SRS does not enter the diagnosis mode if no malfunction is detected in the user mode.

Is malfunctioning part detected? YES >> Refer to SRC-146, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

WARNING:
• Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.) • Never use unspecified tester or other measuring device.

1.CHECK HARNESS CONNECTOR

Check the harness connector.

Is the inspection result normal? YES >> GO TO 2.

NO >> Replace harness connectors.

2.CHECK WIRING HARNESS

Check the wiring harness externals.

Is the inspection result normal? YES >> GO TO 3.

NO >> Replace wiring harness.

3.REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

1. Replace air bag diagnosis sensor unit. Refer to SR-30, "Removal and Installation".

2. Perform DTC confirmation procedure. Refer to SRC-146, "DTC Logic".

Is DTC detected? YES >> GO TO 1.

NO >> INSPECTION END

    B1215, B1216, B1217 satellite sensor LH
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” usi ...

    B1234, B1235, B1236, B1237, B1238, B1239 diagnosis sensor unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” usi ...

    Other materials:

    Roof side molding
    Exploded View 1. Roof side molding 2. Roof side molding clip 3. Double-sided tape [t: 2.5 mm (0.098 in)] 4. Body side outer panel 5. Roof panel : Vehicle front : Do not reuse Removal and Installation REMOVAL ROOF SIDE MODLDING 1. Disengage roof side molding rear side fixing clip, usi ...

    Rear door finisher
    Exploded View 1. Rear door panel 2. Grommet 3. Rear door corner cover inner 4. Cap 5. Power window switch finisher 6. Rear door finisher : Clip : Pawl : Metal clip Removal and Installation REMOVAL CAUTION: • When removing, always use a remover tool that is made of plastic. • ...

    Air conditioner filter
    Exploded View LHD models 1. A/C unit assembly 2. Air conditioner filter 3. Filter cover Removal and Installation (LHD models) REMOVAL 1. Remove glove box assembly. Refer to IP-13, "Removal and Installation". 2. Remove filter cover (1), and then remove air conditioner filter (2) ...