Nissan Juke Owners Manual : Locking with power door lock switch

Driver’s armrest
Operating the power door lock switch will lock or unlock all the doors. The switch is located on the driver’s door armrest.
To lock the doors, push the power door lock switch to the lock position 1 with the driver’s door open, then close the door.
When locking the door this way, be sure not to leave the key inside the vehicle
.
To unlock the doors, push the power door lock switch to the unlock position
Lockout protection
Lockout protection function helps to prevent the keys from being accidentally locked inside the vehicle.
For models with Intelligent Key system:
• When the power door lock switch is moved to the lock position with the ignition switch placed in the ACC or ON position and any door open, all doors will lock and then unlock automatically.
• When the power door lock switch is moved to the lock position with the Intelligent Key left in the vehicle and any door open, all doors will unlock automatically and a chime will sound after the door is closed.
For models without Intelligent Key system:
When the power door lock switch is moved to the lock position with the key in the ignition switch and any door open, all doors will lock and then unlock automatically.
Locking with inside lock knob
To lock the door without the key, move the inside lock knob to the lock position1
then close the door.
To unlock, move the inside lock knob to the unlock position2 .
When locking the door withou ...
Automatic door locks
All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h).
• All doors unlock automatically when the ignition switch is placed in the OFF
position (models with Intelligent Key ...
Other materials:
Structure and operation
Sectional View
1. 3rd input gear
2. 3rd-4th synchronizer hub assembly
3. 4th input gear
4. 5th input gear
5. 5th-6th synchronizer hub assembly
6. 6th input gear
7. Transaxle case
8. 6th main gear
9. 5th main gear
10. 4th main gear
11. 3rd main gear
12. 2nd main gear
13. 1st-2n ...
P0826 up and down shift SW
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch
OFF and wait at least 10 seconds before conducting the next test.
After the repai ...
P0137 HO2S2
DTC Logic
DTC DETECTION LOGIC
The heated oxygen sensor 2 has a much longer switching time
between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen
storage capacity of the three way catalyst (manifold) causes the
longer switching time. To judge the malfunctions of heated oxygen
...
