Nissan Juke Owners Manual : Automatic door locks
All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h).
• All doors unlock automatically when the ignition switch is placed in the OFF position (models with Intelligent Key system).
• All doors unlock automatically when the key is removed from the ignition switch (models without Intelligent Key system).
The automatic unlock function can be deactivated or activated.
To deactivate or activate the automatic door unlock system, perform the following procedure.
1. Close all doors.
2. Place the ignition switch in the ON position.
3. Within 20 seconds of performing step 2.
• Push and hold the power door lock switch to the (UNLOCK) position for more than 5 seconds.
4. When activated, the hazard warning lights will flash twice. When deactivated, the hazard warning lights will flash once.
5. The ignition switch must be placed in the OFF and ON position again between each setting change.
When the automatic door unlock system is deactivated, the doors do not unlock when the ignition is placed in the OFF position. To unlock the door manually, use the inside lock knob or the power door lock switch.
Locking with power door lock switch
Driver’s armrest
Operating the power door lock switch will lock or unlock all the doors. The switch
is located on the driver’s door armrest.
To lock the doors, push the power door lock switc ...
Child safety rear door lock
Child safety rear door locks help prevent the rear doors from being opened accidentally,
especially when small children are in the vehicle.
When the levers are in the lock position 1 , the rear d ...
Other materials:
Contents
• A QUICK REFERENCE INDEX, a black tab (e.g.
) is provided on the first page. You can quickly find the
first page of each section by matching it to the section's black tab.
• THE CONTENTS are listed on the first page of each section.
• THE TITLE is indicated on the upper portion of ea ...
Nats antenna AMP
Removal and Installation
REMOVAL
1. Remove the cluster lid A. Refer to IP-13, "Removal and Installation".
2. Remove the NATS antenna amp.
1. Disengage the NATS antenna amp. (1) fixing pawls using
minus driver etc.
2. Pull NATS antenna amp. to remove it from push-button ignition
sw ...
Ignition coil, spark plug and rocker cover
Exploded View
1. Ignition coil
2. Spark plug
3. Rocker cover
4. Hose cramp
5. PCV hose
6. PCV valve
7. O-ring
8. Gasket
9. Oil filler cap
10. O-ring
11. Camshaft position sensor (INT)
12. Camshaft position sensor (EXH)
13. Cramp
A. To intake manifold
: Always replace after e ...
