Nissan Juke Service and Repair Manual : Nats antenna AMP

Removal and Installation

REMOVAL

1. Remove the cluster lid A. Refer to IP-13, "Removal and Installation".

2. Remove the NATS antenna amp.

1. Disengage the NATS antenna amp. (1) fixing pawls using minus driver etc.

2. Pull NATS antenna amp. to remove it from push-button ignition switch (2).

: Pawl


INSTALLATION


INSTALLATION

Install in the reverse order of removal.

    Push-button ignition switch
    Removal and Installation REMOVAL 1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and Installation". 2. Remove the push-button ignition switch. 1. Disengage the push-button ...

    Other materials:

    Direct injection gasoline system
    Direct injection gasoline system : System Diagram Direct injection gasoline system : System Description INPUT/OUTPUT SIGNAL CHART *1: This sensor is not used to control the engine system under normal conditions. *2: CVT models *3: M/T models *4: ECM determines the start signal status by ...

    B1035 crash zone sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning la ...

    Changing engine coolant
    Major cooling system repairs should be performed by a NISSAN dealer. The service procedures can be found in the appropriate NISSAN Service Manual. Improper servicing can result in reduced heater performance and engine overheating. WARNING • To avoid the danger of being scalded, never change t ...