Vehicle security alarm does not activate

Description Alarm does not operate when alarm operating condition is satisfied. NOTE: Check that vehicle is under the condition shown in “CONDITIONS OF VEHICLE (OPERATING CONDITIONS)” befo ...

Nats antenna AMP

Removal and Installation REMOVAL 1. Remove the cluster lid A. Refer to IP-13, "Removal and Installation". 2. Remove the NATS antenna amp. 1. Disengage the NATS antenna amp. (1) fixing ...

Other materials:

SPEED LIMITER MAIN SWITCH
Component Function Check 1.CHECK SPEED LIMITER MAIN SWITCH FUNCTION With CONSULT-III 1. Turn ignition switch ON. 2. Select “SL MAIN SW” in “DATA MONITOR” mode of “ENGINE” using CONSULT-III. 3. Check “SL MAIN SW” indication as per the following condition. Without CONSULT-III ...

Key warning lamp
Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “INDICATOR” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> K ...

P0037, P0038 HO2S2 heater
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition swit ...