Nissan Juke Service and Repair Manual : Push-button ignition switch

Removal and Installation

REMOVAL

1. Remove the NATS antenna amp. Refer to SEC-167, "Removal and Installation".

2. Remove the push-button ignition switch.

1. Disengage the push-button ignition switch fixing pawls using minus driver etc.

2. Press the push-button ignition switch to remove it from cluster lid A (2).

: Pawl


INSTALLATION


INSTALLATION

Install in the reverse order of removal.

    Nats antenna AMP
    Removal and Installation REMOVAL 1. Remove the cluster lid A. Refer to IP-13, "Removal and Installation". 2. Remove the NATS antenna amp. 1. Disengage the NATS antenna amp. (1) fixing ...

    Other materials:

    All-Wheel Drive (AWD) mode switch operations
    AWD mode switch The All-Wheel Drive (AWD) system is used to select the 2WD (Two-Wheel Drive), AWD-V or AWD mode depending on the driving conditions. The AWD mode indicator lights ( (green), ) are located in the instrument panel. The AWD mode indicator lights (green) illuminate when the ig ...

    Camshaft
    *: Total indicator readin VALVE LIFTER VALVE CLEARANCE *: Approximately 80°C (176°F) AVAILABLE VALVE LIFTER ...

    Intelligent key battery
    Removal and Installation 1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key. 2. Insert a flat-blade screwdriver (A) wrapped with a cloth into the slit of the corner and twist it to separate the upper part from the lower part. CAUTION: • Do not touch ...