Exhaust Manifold

...

Cylinder Head

VALVE DIMENSIONS VALVE GUIDE VALVE SEAT *1: Diameter made by intersection point of conic angles “α1” and “α2” *2: Diameter made by intersection point of conic angles “α2” ...

Other materials:

P1811 power supply circuit for 4wd control module
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

Side oil seal
Removal and Installation REMOVAL 1. Remove front drive shafts. (MR16DDT) Refer to FAX-22, "LEFT SIDE : Removal and Installation" (LEFT SIDE) and FAX-24, "RIGHT SIDE : Removal and Installation" (RIGHT SIDE). 2. Remove front drive shafts. (K9K) Refer to FAX-78, "LEFT SID ...

Buzzer (combination meter)
Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “INSIDE BUZZER” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? Yes >> Buzzer (combi ...