Nissan Juke Service and Repair Manual : Engine Mechanical MR16DDT
- Precautions
- Precaution for Procedure without Cowl Top Cover
- Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
- Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
- Draining Engine Coolant
- Disconnecting Fuel Piping
- Precaution for Handling High Pressure Fuel System
- Removal and Disassembly
- Inspection, Repair and Replacement
- Assembly and Installation
- Parts Requiring Angle Tightening
- Liquid Gasket
- Preparation
- Basic inspection
- Symptom diagnosis
- Periodic maintenance
- Removal and installation
- Engine cover
- Air cleaner and air duct
- Intake manifold
- Charge air cooler
- Catalyst
- Turbocharger
- Exhaust manifold
- Oil pan (lower)
- High pressure fuel pump and fuel hose
- Fuel injector and fuel tube
- Ignition coil, spark plug and rocker cover
- Unit removal and installation
- Unit disassembly and assembly
- Oil seal
- Valve oil seal
- Front oil seal
- Rear oil seal
- Cylinder head
- Oil pan (upper)
- Cylinder block
- How to select piston and bearing
- Service data and specifications (SDS)
Inspection and adjustment
ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL
ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Required
Procedure After Battery Disconnection
*: Not equipped. ...
Precautions
...
Other materials:
B2109 steering lock relay
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2109 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
PCS-30, "DTC Logic".
• When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1
second), the DTC B2109 may be
detected.
...
P2A00 A/F sensor 1
DTC Logic
DTC DETECTION LOGIC
To judge the malfunction, the A/F signal computed by ECM from the A/F sensor
1 signal is monitored so it will
not shift to LEAN side or RICH side.
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always ...
Diagnosis and repair work flow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW FOR MALFUNCTION
Interview the symptom to the customer.
>> GO TO 2.
2.SYMPTOM CHECK
Check the symptom from the customer's information.
>> GO TO 3.
3.BASIC INSPECTION
Check the operation of each part. Check that any sym ...
