Nissan Juke Service and Repair Manual : Assembly and Installation

• Use torque wrench to tighten bolts or nuts to specification.

• When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, do exactly as specified.

• Replace with new gasket, packing, oil seal or O-ring.

• Thoroughly wash, clean, and air-blow each part. Carefully check engine oil or engine coolant passages for any restriction and blockage.

• Avoid damaging sliding or mating surfaces. Completely remove foreign materials such as cloth lint or dust.

Before assembly, oil sliding surfaces well.

• Release air within route when refilling after draining engine coolant.

• After repairing, start the engine and increase engine speed to check engine coolant, fuel, engine oil, and exhaust gases for leakage.

    Inspection, Repair and Replacement
    Before repairing or replacing, thoroughly inspect parts. Inspect new replacement parts in the same way, and replace if necessary. ...

    Parts Requiring Angle Tightening
    • Use the angle wrench [SST: KV10112100 (BT8653-A)] for the final tightening of the following engine parts: - Camshaft sprocket (INT) bolt - Cylinder head bolts - Main bearing cap bolts - Conn ...

    Other materials:

    If the Li-ion battery becomes completely discharged
    Should the power limitation indicator light illuminate while you are driving your Nissan Leaf, be aware that the system has restricted the output of the traction motor. This is an intentional safety feature designed to preserve remaining energy, and you will notice a correspondin ...

    Anti-lock Braking System (ABS)
    WARNING While the Anti-lock Braking System (ABS) is a highly advanced safety feature, it cannot override the laws of physics or compensate for reckless and dangerous driving. The primary role of the ABS is to help the driver maintain steering control and vehicle stability during hard ...

    P183C decel G sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...