Nissan Juke Service and Repair Manual : Parts Requiring Angle Tightening
• Use the angle wrench [SST: KV10112100 (BT8653-A)] for the final tightening
of the following engine parts:
- Camshaft sprocket (INT) bolt
- Cylinder head bolts
- Main bearing cap bolts
- Connecting rod cap bolts
- Crankshaft pulley bolt (No the angle wrench is required as bolt flange is
provided with notches for angle
tightening)
• Do not use a torque value for final tightening.
• The torque value for these parts are for a preliminary step.
• Ensure thread and seat surfaces are clean and coated with engine oil.
Assembly and Installation
• Use torque wrench to tighten bolts or nuts to specification.
• When tightening nuts and bolts, as a basic rule, equally tighten in several
different steps starting with the
ones in center, t ...
Liquid Gasket
REMOVAL OF LIQUID GASKET SEALING
• After removing mounting nuts and bolts, separate the mating surface
using the seal cutter [SST: KV10111100 (J-37228)] (A) and
remove old liquid gasket sealing.
...
Other materials:
Ambient sensor
Removal and Installation
REMOVAL
1. Remove bumper fascia assembly. Refer to EXT-13, "Removal and
Installation".
2. Disengage fixing pawl, and then remove ambient sensor (1)
from air guide RH.
: Pawl
3. Disconnect ambient sensor connector (2), and then remove
ambient sensor.
INS ...
Oil cooler
Exploded View
1. Cylinder block
2. Water pipe
3. O-ring
4. O-ring
5. O-ring
6. Oil cooler
7. Connecting stud
8. O-ring
9. Oil filter bracket
10. Oil pressure switch
11. Oil filter
12. O-ring
13. Connecting bolt
A. : To radiator lower hose
B. : To water pump
: N·m (kg-m, ft ...
Cup holders
CAUTION
• Avoid abrupt starting and braking when the cup holder is being used
to prevent spilling the drink. If the liquid is hot, it can scald you or your passenger.
• Use only soft cups in the cup holder.
Hard objects can injure you in an accident.
Center console
Door (front a ...
